CopyMinder Knowledge Base

Browse By Category:
Look Up Error Number:

Glossary   |   Contact Us

How do I change the protection parameters for a manual installation after they have installed?

Views: 10741
Rating: 43
Rate It:

You need to do the following:

1.    Make the changes you require on the web site.
2.    Get the user to put ForceWebCheck=Once in the [Main] section of the .cm.ini file.
3.    Get the user to run your program.  It will display the Product Key and Installation Code and prompt them to enter an update code.
4.    Go to to get an update code using their Product Key and Installation code.  
5.    Get the user to enter the update code.
More Help

If this article did not help you to solve your problem, please use the menu at the top of the page to browse or search more articles, or to contact our support team.

Others in this Category
articleVerifying registration email addresses
articleWhat is a suspect installation?
articleRunning an installation on a laptop with occasional internet access
articleCan a single Product Key be used for multiple installations?
articleWhat is the IP address of the CopyMinder server?

© 2023 Microcosm Ltd.

Valid XHTML 1.0 Valid CSS 2.0